Skip to content. | Skip to navigation

Personal tools


Ascarate Park SE C37/A332/A172/X159

  • EPA site number: 48-141-0055
  • State: Texas
  • County: El Paso
  • City: El Paso
  • Address: 650 R E Thomason Loop
  • Site coordinates:
    • Latitude: 31° 44' 48.39" North (+31.746775°)
    • Longitude: 106° 24' 10.10" West (-106.402806°)
    • Elevation: 1122 m (3681 ft)
  • Maintained by: TCEQ El Paso Regional Office/City of El Paso
Area Map Overall site view Street level Map
Northwest North Northeast
Southwest South Southeast
Current Measurements
Monthly Summary Report
Yearly Summary Report
  • Real-time monitoring since: Sunday, September 26, 1999
  • Current status: Active
  • Continuous monitors located at this site:
    • Met Data
    • Ozone
    • Oxides of Nitrogen
    • Carbon Monoxide
    • Fine Particulates (PM-2.5)
  • Non-Continuous monitors located at this site:
    • Carbonyl
    • TSP
  • Parameters currently being monitored:
    • Pollution parameters:
      • Carbon Monoxide
      • Nitric Oxide
      • Nitrogen Dioxide
      • Oxides of Nitrogen
      • Ozone
      • PM-2.5 (Local Conditions) Acceptable
    • Meteorological parameters:
      • Wind Speed
      • Resultant Wind Speed
      • Resultant Wind Direction
      • Maximum Wind Gust
      • Standard Deviation of Horizontal Wind Direction
      • Outdoor Temperature
      • Dew Point Temperature
      • Relative Humidity
      • Visibility
      • Solar Radiation
      • Barometric Pressure
  • Parameters that have been monitored but are no longer active:
    • Pollution parameters:
      • PM-10 (Standard Conditions)
      • PM-2.5 (Local Conditions)

PLEASE NOTE:  This data has not been verified by the TCEQ and may change. This is the most current data, but it is not official until it has been certified by our technical staff. Data is collected from TCEQ ambient monitoring sites and may include data collected by other outside agencies. This data is updated hourly. All times shown are in local standard time unless otherwise indicated.

Following EPA reporting guidelines, negative values may be displayed in our hourly criteria air quality data beginning 1/1/2013, down to the negative of the EPA listed Method Detection Limit (MDL) for the particular instrument that made the measurements. The reported concentrations can be negative due to zero drift in the electronic instrument output, data logger channel, or calibration adjustments to the data. Prior to 1/1/2013, slightly negative values were automatically set to zero.